neomisit-logo_en

Do you have a question about your Neomitis RT7 Thermostat? Explore Neomitis videos, user guides and FAQ’s for more information.

Programming – [Tutorials RT7 RF room thermostat]

Temperature setting – [Tutorials RT7 RF room thermostat]

Boost – [Tutorials RT7 RF room thermostat]

Set 12 or 24 hours clock – [Tutorials RT7 RF room thermostat]

Program lock – [Tutorials RT7 RF room thermostat

Pairing – [Tutorials RT7 RF room thermostat]

Mode selection and description – [Tutorials RT7 RF room thermostat]

Manual : a temporary change – [Tutorials RT7 RF room thermostat]

The boiler is not heating

Check that the Thermostat is calling for heat if yes then the thermostat would appear to be working check that the boiler has not switched itself off.
If no increase set temperature.
Check the position of the batteries. Remove them for 30 seconds and reinsert them. If the problem persists, replace the 2 batteries.

Nothing in the display

Check the position of the batteries. Remove them for 30 secondes and reinsert them. If the problem persists, replace the 2 batteries.

The room temperature is not high enough, the boiler is not providing enough heat

Check the active operating mode (see page 3) – the room thermostat
may be in an Eco, Standby or Auto Mode entailing a temperature drop.
Check the active desired temperature and increase it if needed

The temperature in the room is lower than the setpoint temperature

Check the programming. The thermostat could be in a scheduled Eco
period
Ensure that the time displayed is the same as the current time.

You made a mistake while setting

You just need to restore factory settings, as explained in the “Factory settings” section. This will reverse any changes you might have made

The system is not heating but flame icon is on

If a flame indicator light is on but the system remains cold, then you should contact your installer.

Display disappears on thermostat

Check batteries.
Replace the 2 batteries. Only use alkaline 1.5V AA (LR6) batteries.
Do not use rechargeable batteries

The heating does not come on or does not go off

Your room thermostat may have been set up close to a source of heat or on a cold wall – put it in a recommended location.
Check that the communication works between the thermostat and the boiler.

You want to change the operating mode but when you move the mode slider nothing happens

If the lock symbol is being displayed, then the thermostat is locked.
Unlock the thermostat by following the instructions for doing so in the “program lock” section

The thermostat is in Auto Mode but programs are not being executed by the boiler

Ensure that the thermostat is in good working
Change the batteries.

The thermostat does not control properly

Thermostat sensor may be influenced by a source of heat or cold.
Check that the communication works between the thermostat and boiler.